SPECIFYING A PLANE BY USING OF THE DIHEDRAL ANGLE

  • Liviu PRUNA Technical University of Iasi
  • Andrei SLONOVSCHI "Gheorghe Asachi" Technical University of Iasi
Keywords: Descriptive geometry, dihedral angles, Inventor, AutoCAD

Abstract

Sometimes, in the drawing's process of a part, it is necessary to be determine a plane by using the value of the dihedral angle between this and another plane, which is already known. The authors did not find in the literature solutions for this problem, but they observed that can be easily found only methods for measuring of the dihedral angle. Starting from these considerations, in this paper, the authors propose two solutions for specifying a plane by using the dihedral angle, then compares them and recommend one of the two. Finally, the authors present the solutions offered for this problem by the computer programs when 3D model is used.

Author Biographies

Liviu PRUNA, Technical University of Iasi

Director of Department, Technical University of Iasi, Faculty of Civil Engineering and Building Services, Department of Engineering Graphics.

Andrei SLONOVSCHI, "Gheorghe Asachi" Technical University of Iasi

"Gheorghe Asachi" Technical University of Iasi, Faculty of Civil Engineering and Building Services, Department of Engineering Graphics

References

1 Hawk, M.C. (1962). Descriptive Geometry, Schaum Publishing Company, New York
2 Pruna, L., Slonovschi, A., Antonescu, I., Popescu, F. (2002). Geometrie descriptive, Editura Cermi, ISBN 973-8188-25-3, Iasi.
3 Danaila, W.L., Anghel, A.A. (2006). Descriptive Geometry, Editura Tehnopres, ISBN (10) 973-702-345-5, ISBN (10) 978-973-702-345-2, Iasi
Published
2019-05-10
How to Cite
PRUNA, L., & SLONOVSCHI, A. (2019). SPECIFYING A PLANE BY USING OF THE DIHEDRAL ANGLE. Journal of Industrial Design and Engineering Graphics, 14(1), 41-44. Retrieved from http://www.sorging.ro/jideg/index.php/jid/article/view/422
Section
Articles