A SAFETY VALVE MODELLED IN SOLIDWORKS FOR TEACHING SOLIDWORKS AND ASSEMBLY DRAWING
Keywords:
Technical drawing, SolidWorks, safety valve, teaching assembly drawing, elastic assembly.Abstract
Teaching the assembly drawing is done conveniently using a high-level program such as SolidWorks, very flexible, easy to use. Thus, teaching assembly drawing in technical drawing can be combined with teaching SolidWorks. Each component is modelled starting from a sketch and then the components are assembled so that finally the assembly can be sectioned for a perfect visualization of the contact between the components. The correctness of the assembly can be verified by visualizing the contacts between the components. Finally, the 2D assembly drawing is extracted according to the standards.
Downloads
References
Introducing Solidworks, 3D Experience Company,
available at: https://my.solidworks.com/solidworks/
guide/SOLIDWORKS_Introduction_EN.pdf.
Accessed: 2026-01-15
SolidWorks Help, available at:
http://help.solidworks.com/2015/english/SolidWorks/s
ldworks/c_introduction_toplevel_topic.htm,
Accessed: 2025-01-15.
Maican E. (2006). SolidWorks 3D Modeling for
Engineers (SolidWorks Modelare 3D pentru
ingineri), Editura Printech, ISBN 973-718-544-7 978
-718-544-0, Bucuresti.
AutoCAD Mechanical 2D drawing, available at:
https://www.youtube.com/watch?v=s9JIUSyu_O0&li
st=PL970B66C256FA05E1&index=55,
Accessed:
-04-20.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
